STUDY OF A G+6 STOREY HOSPITAL BUILDING RETROFITTING BY USING ETABS SOFTWARE

Authors

  • Mala Manikantha Student, Department of Civil Engineering, Bheema Institute of Technology and Science, Adoni, A.P Author
  • Mrs. Nandini Reddy Assistant Professor, Department of Civil Engineering, Bheema Institute of Technology and Science, Adoni, A.P Author

Keywords:

Remolding, Rehabilitation, Repairing, Fortifying, Retrofitting

Abstract

Over the last three decades, earthquakes have 
struck several sections of the nation.  It was 
discovered that many of the damaged buildings 
in the first three earthquakes were constructed 
using non-engineered masonry methods.  In the 
event of an earthquake, unreinforced masonry 
constructions 
natural hazards and their impact on structures, 
retrofitting 
refers 
to 
advancements 
in 
construction technology, encompassing both 
techniques and materials.  Many of the homes in 
existence today were constructed at a time when 
little 
are 
the 
most susceptible.  
Typically, they are designed to support vertical 
loads, and since masonry has a sufficient 
compressive strength, the structures function 
well under vertical stresses.  The walls of such a 
masonry building experience shear and flexural 
stresses when they are exposed to lateral inertial 
loads during an earthquake.  
Due to poor 
construction, some R.C.C. buildings have fallen 
during past earthquakes and are now deemed 
dangerous.  Major collapse and damage to the 
R.C.C. buildings are caused by several 
additional factors.  

References

Murty CVR, (2002), quantitative approach to seismic strengthening Of RC Frame building, Seminar on seismic assessment and retrofitting buildings, pp19-27.

Sudhir K. Jain, Srikant T, (2002), analysis for seismic retrofitting of buildings,The Indian concrete journal, pp 479-484.

Lakshmanan D, (2006), seismic evaluation of retrofitting of building and Structures, ISET journal of earthquake technology, 43(1-2), pp 31-48.

Shailesh Kr. Agrawal, Ajay Chourasia, (2003), “Nonlinear static analysis for Seismic evaluation and retrofit of RC buildings”, Workshop on rertofitting of structures, pp 116-124.

Abhijit Mukherjee, Amit R. Kalyani, (2004), “Seismic retrofitting of reinforced concrete frames with fiber reinforced composites”, Workshop on Seismic evaluation and retrofitting of building, pp 74-82.

Abdullah, A; and Takiguchi, K, “Experimental Investigation on Ferrocement as an Alternative Material to Strengthen Reinforced Concrete” Column,” Journal of Ferrocement, V. 30, No. 2, pp. 177-190.

ACI-ASCE Committee 352;“Recommendations for design of beam-column connections in monolithic reinforced concrete structures” (ACI 352R- 02), ACI; 2002; pp37.

Al-Salloum, Y.A; Al-Sayed, S. H; Al- Musallam, T. H. & Siddiqui, N. A; (2002),

AL-Sulamani, G.J; and Basunbul, I.A; (1991),

Andrews, G; and Sharma, A, K (1998), “Repaired Reinforced Concrete Beams” ACI, Concrete International, Detroit, ppt .47-50.

Jong – Wha Bai, (2003), seismic retrofit for reinforced concrete building structures, Consequence based engineering institute final report, Mid-America earthquake centre.

Yogendra Singh, (2003), “Challenges in retrofitting of RC buildings” ,Workshop on retrofitting of structures IIT Roorkee, pp 29-44.

Amlan, Sengupta K, Badari VT Narayanan, Asokan A, (2003), “Seismic retrofit of existing multistoried buildings in India-An overview of the method and strategies”, Workshop on retrofitting of structures, IIT Roorkee,pp 17-28.

Giusepe Oliveto, Massimo Marleta, (2005), seismic retrofitting of reinforced concrete buildings using traditional and innovative techniques, ISET journal of earthquake technology, 42(2-3), pp 21-46.

Downloads

Published

2026-04-06